How to Install Quick Change band
- Our Quick Change bands are easily attached & removed with a slide of a spring bar lever.
- These Quick Change bands are made with built-in spring bar that can be removed without using any tools.
- The lever is raised slightly above the watch band to allow you to remove the spring bar by sliding it with your finger.
Step 1: Flipping the watch over, slide in left side of pin into pin hole.
Step 2: Pull back quick release latch and line up with right side of watch. Release latch allowing pin to secure tightly to watch.
Step 3: Repeat step 2 and 3 for other end of strap and enjoy your new strap!
